#Lst server banned serial#

For this reason, it is best to set this value in the Service Parameter Configuration window in Cisco Unified CM Administration so that the value can be validated against the accepted range of values for this field. It is possible that the Stop Bits value has been updated via AXL or a CLI command where validation of the value was not performed.

#Lst server banned serial#

% UC_CMI-1-StopBitConfigurationError:В %:В The Cisco Messaging Interface service parameter, Stop Bits, has an invalid configuration.Д®xplanation An invalid stop bit has been configured for the serial port that CMI uses to connect to the voice messaging system. Recommended Action Informational purpose only no action is required % UC_CMI-6-CMIServiceStatus:В %:В Service is running and working properly.Д®xplanation CMI service is running and working properly If this occurs, the error message is given a severity-level of 3, irrespective of the default severity-level for that error message. If the error message contains UNKNOWN_PARAMNAME, the parameter immediately following the UNKNOWN_PARAMNAME has not yet been updated in the alarm catalog. Order of the parameters in an alarm message can change and it is decided by the Application or Component. Application or Component may decide not to use that parameter in the alarm message.

Optional parameter is indicated with the notation.